AC repair
Furnace & heating
Heat pumps
Ductless mini splits
Carrier
Trane
GoodmanSeasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Get your free estimateHVAC Company in Dallas, TX
If your furnace has reached the end of its run, our furnace replacement work in Dallas starts with the reality of your house, not a brochure. Much of Dallas’s inner-ring housing was built between the 1920s and the 1950s, with pier-and-beam floors, thin attic insulation and ductwork that was never sized for a modern central system. Pair that with summers that push past 100°F and winter ice events that freeze condensate lines, and a straight equipment swap often isn’t enough. We work on Lennox, Goodman, Rheem, York and five other leading brands, so we know what your system is before we arrive. Call (866) 942-9965.
Why Dallas Homes Are Different
Dallas asks a lot of a heating system. The same attic that bakes through a long humid summer sits above a house that has to hold its own when a hard freeze rolls in, and the freezing spell in February 2021 showed exactly what happens when older plumbing and condensate lines aren’t protected. The heat island over the dense core near downtown pushes attic temperatures higher still, which wears equipment faster than the same unit would last in open country.
Then there’s the housing itself. Across Deep Ellum and East Dallas, pier-and-beam homes often hide original galvanized ductwork and undersized returns in the crawlspace. You go in expecting a furnace changeout and find a duct rebuild waiting. Small postwar brick homes on the Uptown and East Dallas edge were built around window units and space heaters; when those homes convert to central air, the duct system is being designed from scratch, not replaced. That’s why furnace replacement in Dallas is as much a retrofit decision as an equipment decision, and why we look at the whole envelope before quoting.
Styles & brands we work with
- AC repair
- Furnace & heating
- Heat pumps
- Ductless mini splits
- Carrier
- Trane
- Goodman
Our Main Dallas Services
Most Dallas homeowners call us about two things: cooling that can’t keep up in July and a furnace that quits in the first cold snap. Both get the same straight diagnosis.
AC Installation in Dallas
Cooling a Dallas home means sizing for peak load, not average load. We run a load calculation rather than copying the tonnage of the unit coming out, because the older inner-ring homes we see were often fitted with systems that were undersized to begin with. In a brick house near the Baylor and Munger area, that calculation frequently shows the return duct is the real bottleneck. We install Carrier, Trane and Goodman equipment and set the system for the humidity, not just the temperature. For the full process, see our AC Installation in Dallas page.

Furnace Repair in Dallas
Dallas furnaces spend most of the year idle, then get asked to work during a freeze. That idle stretch is when small problems set in: a dirty flame sensor, a drafty flue, a blower that’s been collecting dust since March. We diagnose the actual failure instead of replacing parts until something works, and we check that freeze damage hasn’t reached the condensate line while we’re there. If your system is a Rheem or a York, we’ve worked on that platform before. Details live on our Furnace Repair in Dallas page.

Furnace Replacement in Dallas
Furnace replacement in Dallas is usually a retrofit, not a swap. The pier-and-beam and small postwar homes across East Dallas and Deep Ellum were built before central heat was standard, and the ductwork many of them still carry was never designed for the load a modern furnace delivers. We handle the full job through our Furnace Replacement work: sizing, duct corrections where the crawlspace demands them, and a clean install built for a climate that freezes hard and then bakes.
Furnace Changeout for Aging Systems
Signs you need it
You need a changeout when the furnace is old enough that repeated repairs are outpacing the cost of a new unit, or when the heat exchanger shows cracks that make repair unsafe.
What it costs in Dallas
Typical furnace replacement in Dallas runs in the range of our written estimates, which we set per job after we’ve seen the ductwork and the venting; the written estimate sets the final price.
How we do it
We measure the load, inspect the flue and the return, pull the old unit, correct ducting where the crawlspace requires it, set and commission the new furnace, and test the temperature rise before we hand it back.
Freeze-Hardened Replacement Upgrades
Signs you need it
If the February 2021 freeze burst pipes or killed a condensate line in your home, freeze protection is a sign you need the replacement done right this time.
What it costs in Dallas
Freeze protection is folded into the job estimate rather than billed as a surprise line item; we quote the whole scope on paper and the written estimate sets the final price.
How we do it
We route and insulate condensate lines against a hard freeze, verify the venting handles the load, and check the drain path before the unit goes back into service.
What Furnace Replacement Costs in Dallas
| Item | Typical range in Dallas |
|---|---|
| Furnace repair (before replacement is needed) | $150 – $700 |
| AC repair on the paired cooling system | $150 – $650 |
| Pre-season tune-up | $80 – $200 |
Can you replace my furnace before the next freeze?
Usually, yes. Replacement is scheduled rather than same-day, and we book it around the forecast. We give you a written fixed price and a set install date, then handle the job in one visit when duct corrections aren’t needed. Call (866) 942-9965 for a free estimate.
Should I repair or replace my Dallas furnace?
It depends on the unit, not a sales target. A furnace with a sound heat exchanger and a repairable failure is worth fixing. One that’s been failing repeatedly, or that sits on ductwork too small for it, is usually better replaced. We’ll give you a straight answer.
Brands We Service in Dallas
We work on Lennox, Goodman, Rheem, York, Carrier, Trane, Daikin, Bryant and American Standard – nine brands, premium and value tier alike. We don’t claim to stock parts locally; we identify what your system needs and get it moving. Because we know these platforms, diagnosis is quicker than with a generalist. See our brands for the full list.
Pricing for HVAC Company in Dallas, TX
| Service | Typical range in Dallas |
|---|---|
| AC Repair | $150 – $650 |
| Furnace Repair | $150 – $700 |
| AC Installation | $3500 – $7500 |
| Tune-Up | $80 – $200 |
What pushes price up in Dallas is rarely the equipment itself. It’s the crawlspace: original galvanized ductwork, undersized returns and thin attic insulation that all have to be corrected before a new system can perform. We quote upfront, put it in writing, and the written estimate sets the final price.
See the difference
Before
After
Before
After
Before
AfterNeighborhoods We Serve in Dallas
We work across the older inner-ring neighborhoods where the housing stock makes furnace and AC work genuinely different, and out through the surrounding core. Response is same-day in most of Dallas when you call early, with fast dispatch from 7am to 7pm, Sunday through Friday.
- Deep Ellum (75226)
- East Dallas (75223)
- Uptown and the East Dallas edge (75204)
- The Baylor and Munger area (75246)
Service Area – Cities Near Dallas
Dallas sits at the center of a dense metro, and the same housing and climate conditions carry outward. If you’re just outside the city, we also cover Mesquite, TX, Irving, TX, Garland, TX and Richardson, TX. Older homes in those cities face the same undersized ductwork and freeze exposure, so the approach doesn’t change at the line.
Serving Dallas, TX – Our Local Coverage Area
We serve Dallas and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs About HVAC Company in Dallas
Same-day service is common when you call early, with fast dispatch from 7am to 7pm, Sunday through Friday. We answer 24/7, and a call outside dispatch hours is booked into the next opening. Replacement work is scheduled around your date, not squeezed in.
Most cities require a permit for a system changeout or new installation, so ask Dallas’s building department what your address needs. We work within those requirements and make sure the job is done to the standard the inspection expects. Call (866) 942-9965 with questions before you schedule.
We cover Dallas and the cities around it, including Mesquite, Irving, Garland and Richardson. If you’re unsure whether your address falls inside our range, call and we’ll tell you straight. Estimates are free.
Contact Us for Furnace Replacement in Dallas
If your furnace is on its last winter, or a freeze already showed you what your system can’t handle, call us for a free estimate. We’ll look at the ductwork, size the load and give you a written fixed price. Call (866) 942-9965. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday.
What happens when you call
- 1A real person answersNo phone trees. Talk to a local HVAC pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3A background-checked tech heads outLicensed & insured, typically within the hour.
- 4You approve before work beginsNothing starts until you say go.
What Dallas Customers Say
"Contactor was pitted and chattering. Cheap part, quick fix, and he showed me the burn on the old one so I could see for myself."
- Robert Ziegler"Thermostat had been miswired by whoever installed it, which is why the heat strips were running with the AC. He found it in a few minutes and probably saved me a fortune on the next few electric bills."
- Daniela Reyes"Fixed the immediate issue and was honest that the unit is old enough that I should be saving for a replacement. Slightly more expensive than I hoped but he was upfront before starting."
- Veronica Delgado